The brewing industry is thirsty! It takes about 300 litres of water to make one litre of beer. Water is used in all stages in the production of beer, from growing the hops or barley, from brewing the beer, right up to bottling and transport to the pubs or shops.
So, water is a key concern to brewers. The quality of the water, the cost of the water and the ecological factors of water scarcity are all things to be taken into consideration. Even the disposal of the effluent has to be taken into account.
The unique taste of the beverage will depend upon the water and where it has come from. Guineas take their water not from the local Liffey River but pipe it from the Wicklow mountains where the water has low mineral content.
Tap water is very expensive, and the mineral content could make the beer taste unpleasant, so it is an option only to be used as a last resort in brewing.
But wherever the beer is produced, the water will need some form of treatment. As an example, in Burton-on-Trent the water is hard and many local brewers boil the water to reduce this whereas, in Pilsen where the water is very soft, the brewers add salts to make the water harder.
It’s not just the taste that is affected by where the water comes from. Water-rich with calcium and magnesium is hard water and can significantly raise costs in terms of limescale furring up machinery. it can allow dissolved solids to accumulate in the boilers, where they can cause problems like foaming and limescale deposition.
One in every seven people on Earth suffers from water shortages. In America, some breweries have been hard hit and lost markets and money when restrictions were put in place during periods of drought.
Brewers are looking to methods of recycling their wastewater, as a way to reduce costs and lower their environmental impact.
Although beer is 90-95% water, most of the water used is in the cleaning. It is also needed for cooling and bottling beer. A lot of water is lost through evaporation.
Even before the ingredients to make beer reach the brewery, they have used a great deal of water. Barley uses 15-17 inches of water for satisfactory growth and hops over 50 inches per year.
The three main technologies used to treat water are:
A semi-permeable membrane is used to separate particles, including molecules and ions from water. A high-pressure pump forces the water through but traps the unwanted contaminants, thus purifying the water. The water content can then be adjusted to the specific requirement for that brand of beer.
The pore sizes in a nanofiltration membrane are only 1-10 nanometres (one nanometre equals one billionth of a metre (0.000000001 m). These are slightly larger than the pores in the semi-permeable membrane used in reverse osmosis. It removes calcium and magnesium to soften the water and can be used when reverse osmosis is not considered necessary.
Carbon filtration uses a bed of activated charcoal, which removes pollutants by chemical absorption. The same method can be used in industry to remove hydrogen sulphide from gas – and charcoal tablets are sold under such names as “Windaway” and it is an ingredient of cigarette filters.
Saving water through recycling can save the cost of buying more water. When brewers dispose of water, they have to comply with Environmental Agency effluent regulations. Brewery wastewater is high in volume and high in particulates. It must not be allowed to overwhelm the local sewage and water treatment plants.
So, breweries may need to treat the effluent before sending it on to municipal wastewater treatment centres, and many of the larger breweries are investing in wastewater treatment facilities.
Conical bulk tanks for storage of wastewater prior to treatment are used as equalisation tanks, dosing tanks for storage of coagulants and treatment of wastewater. The steeper conical tanks mean that they can be used as settlement tanks for wastewater.
With increased efficiency, some brewers have managed to halve their water-to-beer ratios. Rainwater harvesting and proper irrigation can make savings in the growing of the crops – and finding and controlling leaks can make huge savings. Installing water meters makes good sense even for small breweries.
Better equipment and tweaking the processes can increase efficiency. Closed-loop cooling systems where the water is recirculated to keep the temperatures correct and float valves to check on how full the vessel is can save water and money.
Enduramaxx plastic conical tanks are perfect for ideal for brewing for use as conical fermenters. They come in a range of capacities and advantages include;
We can supply the fittings you need and frames to hold the tanks steady. We also have a huge range of tanks for water treatment and wastewater treatment. If you would like to contact us on 01778 562810 we will be happy to discuss your specific requirements.